Yamaha EDL7000SE Owner's Manual page 13

(8) Part No. G3907-88231
(10) Part No. 5450 968 1000
WA RNI NG
TO AVOID PERSONAL INJURY
WORK MUST BE CONDUCTED BY CERTIFIED PEOPLE.
FIRST, STOP THE ENGINE AND REMOVE STARTER KEY.
REMOVE THE NEGATIVE TERMINAL OF BATTERY AND CONDUCT THE WORK
TO AVOID AUTOMATIC STARTING BY THE SYSTEM.
ADVICE OF INSPECTION AND CLEANING - TO PREVENT A TR ACKING FAILURE.
2
IN DUSTY CONDITIONS, FOREIGN MATTER CAN ACCUMULATE ACROSS
THE TERMINAL BLOCK (2) OF THE GENERATOR.
1
HEN, WHEN IT GETS WET, ELECTRIC ARCING CAN OCCUR BETWEEN
AIN TERMINALS AND IT CAUSES A SHORT CIRCUIT OF MAIN TERMINALS.
TO PREVENT THE FAILURE, REMOVE THE REAR COVER (1), AND CHECK
FOR THE DUST AND MOISTURE ON THE TERMINAL BLOCK REGULARLY.
(CLEAN WITH APPROVED CLEANING AGENT OR MOISTURE DISPLACER.)
1 REAR COVER IN CASE ANY DISCOLORATION AND DEFORMATION OF THE TERMINAL
BLOCK, REPLACE WITH NEW TERMINAL BLOCK.
2
TERMINAL BLOCK
(12) Part No. 6C040-55591
SAFETY PRECAUTIONS
(9) Part No. 5450 801 1000
DA N GER
TO AVOID SERIOUS INJ URY
OR DEATH:
DO NOT OPERATE OR IDLE
IN NONVENTILATED AREAS,
CARBON MONOXIDE GAS IS
COLORLESS, ODORLESS
AND DEADLY.
DO NOT OPERATE IN WET
OR DAMP CONDITIONS.
(11) Part No. G3907-88331
(13) Part No. G3907-88311 (AUS)
6
WARNI NG
TO AVOID PERSONAL INJURY
OR EQUIPMENT DAMAGE
BEFORE STARTING ENGINE :
(1) TURN OFF GENERATOR
CIRCUIT BREAKER.
(2) TURN OFF ALL SWITCHES
ON ELECTRICAL LOAD.
(3) MAKE CERTAIN LOAD
CONNECTIONS AND POWER
CABLES ARE IN GOOD
CONDITION.