Transtherm studio Installation Instructions

TRANSTHERM STUDIO INSTALLATION INSTRUCTIONS
Instructions for integration (fitting into cupboard with cupboard door in front of
wine cabinet door) of Studio integrated model.

Cabinet dimensions

1. This cabinet requires 10mm clearance both sides so minimum cut out is
560mm for width
2. Minimum height is 640mm as this allows 10mm adjustment of feet for
leveling and for fastening of upper securing plate.
3. Minimum depth measurement is 560mm as the Studio has feet at the rear
which protrude 35mm to ensure that the wine cabinet can not be installed
up against the cupboard/wall at the rear – so with the 560mm depth this
allows 35mm clearance for air circulation
4. The base of the cupboard should be no deeper than 525mm,leaving a
35mm gap at the rear for air circulation up the back of the wine
cabinet.This base section must be elevated off the floor to allow a
ventilation grill to be fitted in kick board.
5. A ventilation grill should be fitted in the kick board to allow minimum
200cm2 airflow.
6. A ventilation grill should also be fitted in the bench top,rear wall at the top
or either side of the cupboard at the top to allow the heat generated by the
wine cabinet to rise and escape.
7. This cabinet has a power switch located on the control panel so power
point location is not critical.
8. This cabinet requires a standard 240 volt/10 amp power point.
9. As with most appliances of today , this cabinet has sensitive electronic
components which are susceptible to damage through lightning and
electricity supply faults.It is therefore advised to use a power surge
protector to avoid problems of this nature.
10. Please see below diagrams for instruction and clarification on installation
procedures including fitting of sliding mechanism and upper securing
plate.
INTEGRATED STUDIO MODEL
H 630mm – 650mm(20mm adjustable feet)
W 540mm
D 557mm