Turn On The Television; Front Panel Controls - Panasonic TX-27LWD500A Operating Instructions Manual

Push the Power Switch to turn the
television ON.
Notes:
1. The TV takes approximately 10 seconds to turn ON. Like your computer, it has to run a number of diagnostic
and software checks before it can display any broadcast channels.
2. The indicator will be red when the television is in Standby, green when the TV is operating and off when the
TV is unplugged.
3. The indicator will flash when a valid code is received from the remote control when a button is pressed.
4. If the television is not going to be used for an extended period, remove the power plug from the wall outlet.
Push the Power Switch to turn the
television ON. Unless your dealer has
already programmed your television then
Auto Setup will begin Please refer to
page 11.
Open the front panel door to gain access
to the Television Controls.
Lift the door at the symbol on
the bottom right hand corner.
TV / AV This button is used to select the input to be displayed on the screen. Pressing the button shows
in turn: DVB, Analogue, AV1, AV2, AV3, AV4, HDMI, PC and back to DVB.
MENU This button displays the main menu. From this menu you can select the Picture, Sound and
Setup menus. See pages12, 13 and 14.
< VOLUME > These buttons are used to turn audio volume lower or higher.
If user menu is displayed these buttons are used to access or adjust user menu
\/ CHANNEL /\ These buttons are used to select the next lower / higher programme number.
If user menu is displayed these buttons are used to move up or down to select user menu
options.
Notes:
1. When the television is in Stand-By it is possible to turn it back on by pressing the POWER Button on the front
panel.
2. This television is designed for the Australian Standard Mains Voltage of 240V 50Hz.

Turn on the television

Front Panel Controls

P an aso nic
Getting Started
Panasonic
options.
9