easybike G3 User Manual page 7

www . easybike - int . com
Using Brake
the G3 come with double disk brake front and rear.
Using the front brake must be very careful because it is very strong brake.
use it soft touch and slow. make sure the front wheel never block.
Never use the front only to brake. more safe is to use only the rear brake and add
the front only if you need very fast stop.
always keep good distance in front to other vehicle to enable safe stop.
since the rider center of gravity is high it is good practice to lay down when use
the front brake for fast stop . otherwise you can loose the control , the rear wheel
can go up quickly if use the front brake too strong.
Adjast and clean the brake
the brake pads need to be clean . dust and sand can come inside and make
noise and damage the brake operation.
clean the brake with degreaser . the degreaser remove the oil out ,then you can
use water with press machine or air compressor.
Adast the brake must be done only by technical professional people.
Never ride the scooter if the brake not operate correct 100% .
good adjust is critical . the brake pads have limit life . replace the pads if need.
don't wait till the pad too thin .
the brake lever must come back when not in use. if the lever not come back
totally the motor will not run.
each brake lever connect with wire to the controller . when you pull the lever the
motor stop.
if the brake lever damaged please replace with new one.
page
6