Initial Selections; Selecting The Input Signal; Selecting The On-Screen Menu Language - Panasonic TH-37PR11UH Operating Instructions Manual

Initial selections

Selecting the input signal

Select the input signals to be connected by installing the optional Terminal Boards.
Notes:
• Selecting is also possible by pressing the INPUT button on the unit.
• Input terminal will not be selected if the terminal board is not installed into the SLOT.
• Select to match the signals from the source connected to the component/RGB input
terminals. (see page 30)
• In 2 screen display, the same input mode cannot be selected for the main picture and
sub picture.
• Image retention (image lag) may occur on the plasma display panel when a still picture
is kept on the panel for an extended period. The function that darkens the screen slightly
is activated to prevent image retention (see page 40), but this function is not the perfect
solution to image retention.

Selecting the On-Screen Menu Language

Press to select the input signal to be played back from the
equipment which has been connected to the Plasma Display.
Input signals will change as follows:
INPUT1 INPUT2
Press to display the SET UP menu.
Press to select OSD LANGUAGE.
Press to select your preferred language.
Selectable languages
English(UK)
Deutsch
Français
Italiano
ENGLISH(US)
INPUT3 PC
Español
.......(Chinese)
.......(Japanese)
.......(Russian)
Русский
INPUT MENU ENTER/
VOL
Swing up the door at "PULL".
SET UP
SIGNAL
SCREENSAVER
COMPONENT/RGB-IN SELECT
INPUT LABEL
POWER SAVE
STANDBY SAVE
POWER MANAGEMENT
AUTO POWER OFF
OSD LANGUAGE
1/2
RGB
PC
OFF
OFF
OFF
OFF
ENGLISH ( US )
13