Table of Contents
Advertisement
Chapter 4 Adjustments and settings for recording
4-4-3 CH3 and CH4 recording levels
Audio signals can be recorded separately for four audio
channels. Perform menu operations to open the <MIC/
AUDIO1> screen from the VTR MENU page to change the
settings for the AUTO LEVEL CH3 and AUTO LEVEL CH4.
Depending on the setting conditions and input level for these
items, recording levels for audio tracks CH3 and CH4
change as shown in the table below. Note that adjustments
cannot be performed manually.
AUTO LEVEL
CH3/CH4*
ON
OFF
<Note>
The DVCPRO HD-LP format allows signals for 8 audio
channels to be recorded, but the same signals as CH1, CH2,
CH3 and CH4 will be recorded for CH5, CH6, CH7 and CH8,
respectively.
38
Downloaded From CamcorderManual.com Panasonic Manuals
Input level
LINE
MIC
AGC ON
AGC ON
AGC/LIMITER OFF
LIMITER ON
(continued)
4-5 Setting the time data
When the user bits and time code are both to be used, the
user bits are set first.
If the time code is set first, the time code generator will stop
while the user bits are being set so that the time code setting
will be off.
The time code setting range extends from 00:00:00:00 to
23:59:59:29.
4-5-1 Setting the user bits
By setting the user bits, information, such as a memorandum
(date, time) of up to 8 digits in hexadecimal numbers, can be
recorded in the sub-code area (LTC) and the VIDEO AUX
area (VITC).
UP (+) button
SHIFT button
OUTPUT/AUTO KNEE switch
1
Set the DISPLAY switch to UB.
2
Set the TCG switch to SET.
3
Set the user bits using the SHIFT button, UP (+) button
and DOWN (–) button.
SHIFT button:
This is used to cause the digit that is
to be set to flash. Each time it is
pressed, the flashing digit moves to
the right.
UP (+) button:
This increments the numerical value
of the flashing digit by 1.
DOWN (–) button: This decrements the numerical value
of the flashing digit by 1.
4
Set the TCG switch to F-RUN or R-RUN.
DISPLAY switch
Display window
TCG switch
DOWN (–) button
Advertisement
Table of Contents
