Chapter 5 How To Integrate With Access Control - Promag WEC200 User Manual

5. How to integrate with Access Control
An adequate component is significant influence, which is very helpful solution to security by
selecting an adequate component.
Electric Lock
Electric Lock is controlled by the terminal of relay No.1 or relay No.2 of WEC200, hence
whichever the electric lock you are using should be able to be compatible with the relay specifications
below:
1. Configuration
Mode: normally-opened (N.O.) and normally-closed (N.C.)
What is N.O.?
It means when deactivation is appearing, the status for the electric lock is unlock, otherwise if
activation is appearing for the electric lock, the status will be switched to lock up.
What is N.C.?
When deactivation is appearing, the status will be switched to lock-up. If activation is
appearing now, and the status will be unlocked relatively.
2. WEC200 supports above two modes.
3. Power Drive for Electric Lock
Able to divide into 2 modes: DC and AC. Some of the electric locks probably support these
two modes, but some of them supports DC mode only. We highly recommend Model DC12V
accordingly, which is also compatible with WEC200.
Suggestion
5