Fundamentals; Powering On The Magellan Roadmate Receiver; Turning The Magellan Roadmate Receiver On; Turning The Magellan Roadmate Receiver Off - Magellan Roadmate User Manual

Fundamentals

Powering on the Magellan RoadMate
receiver
The Power On/Off switch is located on the top
of the Magellan RoadMate receiver.
Turning the Magellan RoadMate receiver
On
1. Press the power switch.
2. After the initial splash screen the
Warnings screen is displayed. Read and
tap .
Turning the Magellan RoadMate receiver
Off
1. Press the power switch. The receiver will
automatically power off in 15 seconds.
[Cancel] cancels the power off sequence
and returns to last viewed screen.
[Power Down Now] turns the receiver
off immediately, bypassing the 15 second
delay.
Note: Anytime the power cable is
disconnected from the receiver or if power is
turned off at the 12v power receptacle, the
receiver will begin the power off sequence.

Battery Levels

The Magellan RoadMate receiver has an
internal battery that is charging whenever
the receiver is connected to external power.
Note: The battery can only be serviced by
authorized Magellan repair facilities.

Viewing the Battery Level Indicator

1. While viewing the Map screen, tap on the
Menu button in the right corner.
2. The battery level indicator is located in
the upper right corner of the Main Menu,
just below the satellite signal indicator.
Green bars indicate battery level.

Speaker Volume

Changing the Volume from the Map
Screen
1. Tap the speaker icon . Additional controls
appear.
2. Tap the speaker button to mute the
volume, or tap the '+' or '-' buttons to raise
or lower the volume.
3. Tap .

Changing the Volume from Settings

1. Access the Main Menu.
2. Tap the Settings icon .
3. Tap Sound.
4. Tap inside the Master volume adjust
bar to change the volume level of the
Magellan RoadMate receiver.
5. Tap to save and exit.

Setting Button Sounds On or Off

1. Access the Main Menu.
2. Tap the Settings icon .
2
3