Other Remote Operations - Panasonic KX-FT74HK Operating Instructions Manual

Other remote operations

Erasing a specific message
Press {*}{4} while listening to the
message you want to erase.
L A long beep and 3 short beeps will
sound. The unit will then play back the
next message.
Erasing all the messages
Press {*}{5} to erase all the messages.
L A long beep and 3 short beeps will
sound.
Monitoring the room
Press {6} to monitor the sound for about 30
seconds in the room where the unit is
installed.
L After 30 seconds, a beep sounds. To
continue monitoring, press {6} again
within 10 seconds.
1. Call your unit.
2. Press the remote operation ID
during the greeting message.
3. Press the remote command key.
Key Remote command
{0} Skips the greeting
message
{1} Repeats a message
{2} Skips a message
{4} New message playback
All message playback
{5}
Room monitor
{6}
Re-records a greeting
{7}
message
Remote Operation (KX-FT78 only)
Answering device remote operation
Key
{9}
{*}{4}
{*}{5}
{8}{0}
{8}{1}
{8}{2}
{8}{3}
{8}{4}
{*}{*}{*}{9} Activates fax function
Recording a marker message
After playing back the recorded messages,
you can leave an additional message.
1. Wait for 3 beeps indicating the end of the
remote operation.
2. Hear 1 beep.
3. Wait about 10 seconds.
4. Hear the voice guide or hear 1 beep.
5. Leave a message.
Re-recording a greeting message
You can change the contents of the
TAD/FAX greeting message.
1. Press {7} to start recording.
L A long beep will sound.
2. Speak clearly up to 16 seconds.
L If you pause for over 2 seconds, 6
beeps will sound and the recording will
stop. Repeat from step 1 within 10
seconds.
3. When finished recording, press {9}.
L The new greeting message will be
played.
Remote command
Stops re-recording of a
greeting message
Erases a specific message
Erases all messages
Changes to TEL mode
Turns on message transfer
Turns off message transfer
Turns on pager call
Turns off pager call
-65-