Firmwareupdate; Reset To Factory Default - Baudisch CP-CAM-AHD ECO / MAX Manual

Baudisch.CP-CAM-AHD ECO / MAXI
5.4.

Firmwareupdate

The latest firmware for the camera module can be downloaded directly from AXIS
Please visit
camera.
5.5.

Reset to factory default

To restore the factory settings, proceed as follows:
•
Disconnect the camera from the power supply and ethernet.
•
Remove the four screws securing the rear cover and remove it.
•
Keep the Control button pressed while you restore the power supply.
•
Hold down the button for about 15 seconds until the status LED is yellow flashing.
•
Release the Control Button. The process is complete when the status LEDs light up
green.
If no DHCP server is active on your network the new default IP is 192.168.0.90 .
The new default user is root with password pass
20131030SC_HB-EN_CP-CAM-AHD-Steel.doc
http://www.axis.com/techsup/
Version 1.1 - Stand: 19.11.2013
and download the firmware for the M1004-W network
17 / 17
Controlbutton
s/15.05.2014