Panasonic KX-FP141AL Operating Instructions Manual page 52

8. Programmable Features
1. Press {MENU}.
2. Press {#}, then {5}{1}.
3. Enter a 3-digit number except a number
using digits 0 or 7.
L The default ID is "555".
4. Press {SET}.
5. Press {MENU}.
Code #52 (KX-FP145 only): Setting the
mailbox 2 password
BOX2 PASSWORD
ID=
To prevent other users from retrieving your
messages, program a password for mailbox 2.
1. Press {MENU}.
2. Press {#}, then {5}{2}.
3. Enter a 3-digit number except a number
using digits 0 or 7.
L The default ID is "555".
4. Press {SET}.
5. Press {MENU}.
Code #54 (KX-FP145 only): Changing the
recording time for your TAD/FAX greeting
message
GREETING TIME
=16s [±]
"16s" (default): Maximum recording time is 16
seconds.
"60s": Maximum recording time is 60 seconds.
See page 38 for details.
Code #55 (KX-FP145 only): Greeting
message for mailbox 1
BOX1 GREETING
CHECK [±]
See page 42 for details.
Code #56 (KX-FP145 only): Greeting
message for mailbox 2
BOX2 GREETING
CHECK [±]
See page 42 for details.
Code #58: Setting the original mode
ORIGINAL
=NORMAL [±]
To send or copy a document with faint or dark
writing, set this feature before starting
transmission or copying.
"NORMAL" (default): Used for normal writing.
50
"LIGHT": Used for faint writing.
"DARKER": Used for dark writing.
Code #60 (KX-FP145 only): Setting the
message transfer
MESSAGE TRANSFER
=OFF [±]
To transfer recorded incoming messages to
another telephone (page 44), activate this
feature and program the transfer telephone
number.
1. Press {MENU}.
2. Press {#}, then {6}{0}.
3. Press {A} or {B} repeatedly to select "ON".
4. Press {SET}.
5. Enter the transfer telephone number.
6. Press {SET}.
7. Press {MENU}.
Code #61 (KX-FP145 only): Checking,
recording or erasing the transfer greeting
message
TRNS-GREETING
CHECK [±]
See page 44 for details.
Code #67 (KX-FP145 only): Setting the
incoming message monitor
ICM MONITOR
=ON [±]
To hear an incoming message (ICM) from the
speaker when the answering device is recording
the message.
"ON" (default): You can monitor the incoming
message.
"OFF": Deactivates this feature.
Code #68: Setting the Error Correction Mode
(ECM)
ECM SELECTION
=ON [±]
This feature is available when the
transmitting/receiving fax machines are ECM
compatible.
"ON" (default): To send a fax even if there is static
interference on the telephone line.
"OFF": Deactivates this feature.
Note:
L You cannot change the setting when received
documents are in memory.