How To Make A Bag From A Foodsaver Roll - FoodSaver V4980 Owner's Manual

How to...
Make a Bag from a FoodSaver
1. Open appliance door (I) and place roll into Roll Storage
(Fig. 1). For best results, insert roll with material flap down.
2. Lift up Roll Cutter Bar (K) and place bag material
beneath the cutter bar (Fig. 2).
3. Pull out enough bag material to hold item being
vacuum sealed, plus 4 inches (10.16 centimeters).
Lower the Roll Cutter Bar and slide Bag Cutter (L)
across the Cutter Bar (Fig. 3).
4. Press Seal Button (D). Red Seal Indicator Light
will illuminate (Fig. 4).
5. Using two hands, slowly insert open end of bag,
curl down, into Vacuum Channel (G) until
clamp motor starts (Fig. 4).
6. When red Seal Indicator Light
sealing is complete. You may remove bag from
the Vacuum Channel (G) (Fig. 4).
7. You now have one sealed end (Fig. 5).
8. Now you are ready to vacuum seal with your new bag
(see next page).
10
6
6 turns off,
www.FoodSaver.com
Roll
®
G
Fig. 1
I
Fig. 2
K
Fig. 3
L
Fig. 4
D
6
Insert Bag Curl Downward
Fig. 5