These problems can be solved if the converter ELO E 171 (MULTI MODE) is applied. Operation principles ELO E171 transfers signal received from RS-485 interface to transmitting fiber of the optic cable and the signal from receiving fiber is transmitted to RS-485.
ELOE171ZKE001 selected (e.g. 8 data bits without parity). 19.2 kbps rate and 9 bits format is set in the picture. When in operation, received and transmitted data and data flow direction is also indicated by LED. RS-485 Interface Connection There is the isolation between the RS-485 interface clamp and all the other converter circuits.
The fibre optic cable is connected through the ST400 connectors. To connect the ELO E171, the transmitter of the remote converter must be connected to the receiver of the local ELO E171 and the remote receiver must be connected to the local transmitter (fibres cross).
Check the RS-485 link connection. Connection in normal Check the power supply operation quit working Check if the cables are OK.. Turn off and on the power supply and detect if the converter starts again. Ordering Information Supply code is ELO E171.