Maximum data rate limit is 115.2 kbps. LED diodes indicate the transmitted and received signal. Installation This part describes the ELO E174 converter installation principles. Optic link connection ST 400 connectors are used to connect the fiber optic cable. To connect two...
ELOE174ZKE002 Signál female RS-422 GND signal Ready Vcc out OUT +5V stínění IN +8V kryt stínění CABLE CONVERTER Power supply connection To supply the converter, the external power supply of 6V via SCJ 2.5mm connector (yellow LED labelled 6V indicates it) or via 9 contact (IN+8V) is used, e.g. from the DTE.
Check if the cables are connected properly. Check if the power supply is on. Check if the DTE works properly. Ordering Information Supply code is ELO E174. Option: Supply code for power supply 6V/200mA is ELO E0Q0.