Basic Connection; Connecting To A Television Only - Panasonic Diga DMR-EZ47VEB Operating Instructions Manual

Basic Connection

Use of the supplied RF coaxial cable
To prevent interference patterns from appearing on your TV, use only the supplied RF coaxial cables when you
connect this unit to your TV and aerial outlet or aerial cable and Satellite receiver.
 Keep the RF coaxial cables as far away as possible from other cables.
 Do not roll up the RF coaxial cables.
 Before connection, turn off the mains for all connected equipment and read the appropriate operating
instructions.
Be sure to read the Caution for AC Mains Lead on page 3.

Connecting to a Television only

To household
mains socket
Step
4
To household
mains socket
AC IN AC IN
Step
4
Use one of the RF coaxial cable (black or grey) to connect this unit's RF IN terminal to your aerial socket or
aerial cable.
 RF coaxial cable (supplied) from the aerial socket or aerial cable to the "RF IN" on the unit.
 RF coaxial cable (supplied, black) from the "RF OUT" on the unit to the "RF IN" on the TV.
 21-pin Scart cable (not supplied) from the "AV1 (TV)" on the unit to the "AV" on the TV.
 AC mains lead (supplied) from the "AC IN~" on the unit and the TV to a household mains socket.
After completing the above connections, proceed to the TV Tuning (
21-pin Scart terminal
The 21-pin Scart terminal transmits both input
and output signals for picture and sound.
TVs equipped with the same type of terminal
can be connected here.
This type of terminal is also called Peritel, Euro
Connector and Euro AV.
 When the unit is connected to a Q Link-
compatible TV with a fully wired 21-pin Scart
cable, You can use convenient functions of Q
Link.
1 3 5 7 9 11 13 15 17 19
2 4 6 8 10 12 14 16 18 20
8
RQT8857
COMPONENT
OUT
VIDEO OUT
Y
VIDEO
P B
L
AUDIO
P R
OPTICAL
R
DIGITAL AUDIO OUT
(PCM/BITSTREAM)
Rear of this unit
To the aerial
21
AV
RF IN
Rear of TV
Step
3
AV 1 A A 1 AV V
(TV) (TV)
OUT
S VIDEO
AV 2 A A
(EXT) T T
RF coaxial cable (supplied, grey)
Step
1
or
RF coaxial cable (supplied, black)
Step
1
Connections other than the 21-pin Scart cable
10).
AV1 Scart terminal (TV)
1 Audio output CH2 (R)
2 Audio input CH2 (R)
3 Audio output CH1 (L)
4 Audio ground
5 Blue ground
6 Audio input CH1 (L)
7 Blue output
8 Switching voltage output
9 Green ground
10 Q Link control signal
11 Green output
12 Reserved
13 Red ground
14 Blanking ground
15 Red output/chrominance output
16 Blanking output
17 Video output ground
18 Video input ground
19 Video output/luminance output
20 Video input
21 Ground
Step
2
The RF coaxial cable cannot
RF RF RF
IN IN IN
be used for showing pictures
from the unit. The unit must
RF RF RF
OUT OUT OUT
be connected using another
method, e.g. 21-pin Scart
cable to show pictures from
the unit on the television set.
To this unit
RF
IN
AV2 Scart terminal (EXT)
1 Audio output CH2 (R)
2 Audio input CH2 (R)
3 Audio output CH1 (L)
4 Audio ground
5 Blue ground
6 Audio input CH1 (L)
7 Blue input
8 Switching voltage input
9 Green ground
10 Reserved
11 Green input
12 Reserved
13 Red ground
14 Blanking ground
15 Red input/chrominance input
16 Blanking input
17 Video output ground
18 Video input ground
19 Video output
20 Video input/luminance input
21 Ground
67–69