Recording from an External Device
Recording from a VCR, etc.
Connect cables while both the unit and the external
device are turned off.
You can get a
sharper, clearer
picture by connecting
with an S Video cable
instead of the yellow
video cable.
S Video cable
Preparation:
Turn on the unit.
[RAM] If the disc is protected, release protection
(
56).
[VHS] Ensure accidental erasure tab is intact.
When the output signal from the external device is
NTSC, change the "TV System" to "NTSC" in the
Setup menu (
63).
This unit cannot record NTSC signals to discs that
already have PAL signal recordings.
To reduce noise in input from a video cassette
recorder, set "Copy NR" to "On" in the on-screen
display (
55).
DRIVE
SELECT
to select the DVD or VHS
drive.
– Insert a disc or video cassette with enough
remaining blank space (
REC MODE
to select the recording
mode (
INPUT
to select the input where
SELECT
your external device is connected.
– Front panel inputs are AV3.
24
RQT8857
Front of the unit
IN 2
S VIDEO
VIDEO
L
/MONO AUDIO R
AV3 IN
S VIDEO
/MONO AUDIO R
VIDEO
L
Yellow White Red
72, 74).
20).
Recording to DVD
[RAM] [-R] [-R]DL] [-RW‹V›] [+R] [+R]DL] [+RW]
Perform steps − left.
Start play on the external device.
REC
start recording to the disc.
Recording to VHS
[VHS]
Perform steps − left.
PLAY
Audio/video
cable
point at which you want to start
recording from.
PAUSE
REC
standby.
Start play on the external device.
PAUSE
point you desire.
Notes
When timer recording starts while recording from an external
device, timer recording takes priority and recording from the
external device stops.
Tips
You can also connect to the AV2 on the rear.
If the audio output of the external device is monaural, connect to
L/MONO on the AV3 input terminals at the front.
To skip unwanted parts
Press [PAUSE] to pause recording. (Press again to restart
recording.)
To stop recording
Press [ STOP].
at the point you want to
to bring the tape to the
when you reach that point.
to put the unit in recording
to start recording at the