Table of Contents
Advertisement
User manual: RS-400G
SAFETY INSTRUCTIONS ......................................................................................................... 2
OPERATING THE LASER ......................................................................................................... 3
Using the laser.......................................................................................................................... 3
Control panel ............................................................................................................................ 3
ILDA mode ................................................................................................................................ 4
DMX mode................................................................................................................................. 4
Maintenace / cleaning ............................................................................................................. 5
Technical specifications........................................................................................................... 5
Change scanner........................................................................................................................ 5
Adjustable mirror mounts ....................................................................................................... 6
Troubleshooting ....................................................................................................................... 6
ILDA signal................................................................................................................................ 6
Technical diagram.................................................................................................................... 7
Please note................................................................................................................................ 7
EU-declaration of conformity.................................................................................................. 8
Checking parts
Please check if all listed parts are included, and are not damaged. Included:
1 x RS-400G Laser
1 x Power cable
1 x 9-pin plug
2 x key
1 x safety cord
1 x manual
SAFETY INSTRUCTIONS
If the device has been exposed to great temperature changes, do not switch it on
immediately. Condensation water may damage your device. Leave the device
switched off until it has reached room temperature.
The laser must only be used for shows. Any operation has to be attended and
supervised by a skilled and well-trained operator.
Never leave this device running unattended and keep it away from children and
unauthorized persons.
Keep away from heaters and other heat sources. In order to safeguard sufficient
ventilation, leave 50 cm of free space around the device.
Never direct the laser beam to people or animals.
CAUTION LASER DIODE: If you open the device for cleaning, always disconnect from
mains!
-HEALTH HAZARD! Never look directly into the light source, as
sensitive persons may suffer an epileptic shock!
These lasers are considered a definite eye hazard,
particularly at the higher power levels, which WILL cause
eye damage. So these laser series models supplied with a
key switch to prevent unauthorized use, warning labels
and aperture labels affixed to the laser.
Installation safety
Prior to installation and operation of the laser, the paths of the
beams and effects should be considered, particularly with
respect to how they will reach the audience. If direct audience scanning is desired, then the
Contents
Page 2 of 8
Rev: 09/2009
Advertisement
Table of Contents
