User manual: CS-500RGBV page2 of 6 Checking parts Please check if all listed parts are included, and are not damaged. Included: 1 x CS-500RGBV laser 1 x Power cable 1 x 9-pin plug (dongle) 2 x key 1 x manual...
User manual: CS-500RGBV page3 of 6 Keep surrounding dry and clean. This unit should be keep dry, do not use in the rain or damp and dusty environment. Projector should be put in a water-proof housing when operated outside. Regularly open the device (see “cleaning” further down) to check for dust inside, or if fog fluid condenses in the housing (if so rearrange hazer and/or laser position).
User manual: CS-500RGBV page4 of 6 ILDA mode When an ILDA compatible interface is connected to the laser, the laser is automatically switched to ILDA mode. Output is then controlled from a PC running software. The laser uses pins 4 and 17 of the IDLA signal to detect the presence of an ILDA interface.
After installing the device, an inspection and official approval is indispensable for the overall setup. The inspection must follow the european guidelines EN 60825-1 and corresponding regulations for the prevention of accidents BGV-B2. This declaration is executed on behalf of the Laserworld CS-500RGBV manufacture Laserworld (Switzerland) AG Oberstrasse 1 8274 Tägerwilen...