INSPECTION OF EQUIPMENT ........3 SELECTION OF INSTALLATION LOCATION ....3 CONDITIONING UNITS CLEARANCES REQUIRED ..........3 MODELS: CH012 - CH060 AND CHECKING THAT THE UNIT IS LEVEL ......3 CU012 - CU060 UNIT MOUNTINGS ............3 UNIT WEIGHTS ..............3 MODEL NUMBER DUCT CONNECTIONS ............
Page 2
036-33073-001 Rev. A (0701) CONTENTS INTRODUCTION ....... . . 3 WARNING INSPECTION OF EQUIPMENT .
036-33073-001 Rev. A (0701) INTRODUCTION CLEARANCES REQUIRED York model CH and CU units are completely self-contained Twenty-four (24) inch clearance is required at each end of the air conditioning units with water-cooled condensers. unit for service access. Eighteen (18) inch clearance is rec-...
036-33073-001 Rev. A (0701) ELECTRICAL POWER SUPPLY AND following performance tables are 230-volt operation. Slightly lower air volumes will be obtained on 208-volt operation. CONNECTIONS TABLE 2: EVAPORATOR BLOWER PERFORMANCE (CFM) Before installing the unit, make sure that the voltage and number of phases on the unit data plate are the same as the Unit Blower...
036-33073-001 Rev. A (0701) TABLE 3: WATER VALVE SIZES valve from the rest of the piping system. A bibcock or a plugged tee fitting should be installed between the shut-off RECOMMENDED VATER VALVE SIZE valves and the unit in both the inlet and outlet pipes. These Water Cooling Tower Mains or Chilled Water connections are to provide for acid cleaning of the condenser,...
036-33073-001 Rev. A (0701) OPERATION required. The compressor is part of a sealed refrigeration system that does not require any additional lubrication. A room thermostat should be used to cycle the unit on and off The only maintenance required is to replace the air filter at automatically as required to maintain the room temperature the return air intake to the cooling coil.
Need help?
Do you have a question about the CH012 and is the answer not in the manual?
Questions and answers