Panasonic Diga DMR-E51 Operating Instructions Manual page 25

ªTo change the programme
TIMER
Remain 1:58 SP
RECORDING
1:19:00 12.7 TUE
Name Date Start Stop Mode
64 ABC 12/ 7 TUE 1:00 2:00 SP
Title
Press ENTER to store new programme.
SELECT
CANCEL No.
0 -- 9
ENTER RETURN
Timer Programme Correction screen (After step 3 on page 24)
1) Use [2, 1] (10) to select the item you want to change.
2) Change the setting with [3, 4] (10).
≥You may use the numeric buttons (4) to enter "Name",
"Date", "Start" and "Stop".
The items change as follows:
≥Name (Programme Position/TV Station Name)
≥Date
Current date>the day before one month later>
Daily (Sunday to Saturday)>Daily (Monday to Saturday)>
Daily (Monday to Friday)>Weekly (Sundays)>...>
Weekly (Saturdays)
≥Start (start time)/Stop (finish time)
The time increases or decreases in 30-minute increments if
you hold the button.
≥Mode (Recording mode)
XP>SP>LP>EP>FR (page 19)
≥Title
Select "Title" and press [ENTER] (10), then refer to page 29
for entering title.
You can give DVD-RAM and DVD-R titles of up to 44
characters.
3) Press [ENTER] (10) when you have finished making changes.
The Timer Programme List screen appears.
ªIf "– –" appears under "Name" after entering a
G- number
CODE
Name stands for Programme Position/TV Station Name.
Normally, the name of the TV station or the number of the
programme position is displayed under "Name".
However, if the TV station information was not automatically set
during Auto Setup due to adverse reception conditions, the "– –"
indication appears instead.
In such a case, follow the operation steps below to correct it.
Use [3, 4] (10) repeatedly to select the programme
position on which the TV programme to be recorded
will be broadcast.
After you have entered the information of a TV station, it remains
stored in the unit's memory, and you do not need to enter it again
in the future.
Notes
≥The built-in clock employs 24-hour system.
≥The actual time recorded may be longer than the programme
itself when television programmes are recorded using G-
≥"Invalid Entry" is displayed when you enter the wrong code.
Reenter the code.
≥"PROG FULL" is displayed in the unit's display if there are already
16 items programmed. Delete unnecessary items (page 27).
≥The remaining time displayed is calculated based on the current
recording mode.
≥When recording more than one programme in a row, for DVD-
RAM the first few seconds, and for DVD-R about the first 30
seconds of all programmes from the second one onwards will not
be recorded.
≥Recording is not possible unless you set "Disc Protection" in
"DISC INFORMATION" to "Off". (page 30)
≥You can not record to a disc if the write protect tab on a cartridge
disc is set to protect. Release this before operation (page 64).
≥Even if the unit is put in the timer recording standby mode or the
timer recording is being performed, you can play a programme.
25
Timer recording (continued)
CODE
.