Ambilight Inverter Panel; Control Panel; Side I/O Panel; Audio Panel - Philips BJ3.0E Service Manual

Table of Contents

Advertisement

4.3.5

AmbiLight Inverter Panel

There are two AmbiLight Inverter Panels used in this set. The
instructions to remove the right one (seen from the back side of
the set) are as follows:
1. Disconnect the cables [1] from the panel.
2. Push back the clamps [2] on the right side that hold the
assy.
3. Take out the panel (it hinges on the left side).
When defective, replace the whole unit.
1 1
Figure 4-7 AmbiLight right side inverter panel removal
4.3.6

Control Panel

The Control Panel can be taken out by removing the two T10
screws [1] that hold the plastic frame. See Figure "Control
panel removal". The cable can not be disconnected from the
assy at this moment. While still connected to the assy, the
cable must now be released from the two clamps on the
chassis nearest to the assy.
1 1
Figure 4-8 Control panel removal
Mechanical Instructions
The assy is packed into two plastic frames. To unpack the
inner frame, lift the two clamps [1] of the outer frame and take
the inner frame out. See Figure "Control panel frame removal".
To take the assy out of the inner frame, lift the two clamps of
the frame [2] and slightly pull the assy out. Only now the cable
can be disconnected.
When defective, replace the whole unit.
4 2
4.3.7

Side I/O Panel

The Side I/O Panel can be removed together with its plastic
frame.
1. Disconnect the USB cable and the flat cable [1] from the
2. Push the plastic frame slightly downwards towards the
3. Push back the clamps [3] on the left side that hold the assy.
4. Take out the assy from the plastic frame, it hinges on the
When defective, replace the whole unit.
G_15960_110.eps
070306
4.3.8

Audio Panel

G_15960_099.eps
1. Disconnect all cables from the Audio Panel.
070306
2. Remove the two T10 mounting screws [1] from the Audio
3. Take out the Audio Panel (it hinges at the right side).
BJ3.0E PA
1 1
1 2
Figure 4-9 Control panel frame removal
panel.
bottom of the set [2], and take the frame out together with
the assy.
right side.
3
4 1
Figure 4-10 Side I/O panel removal
Panel. See Figure "Audio Panel removal".
4.
EN 11
G_15960_100.eps
070306
2 2
G_15960_098.eps
100306

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents