Installing The Modules - Avaya P550R Installation Manual

Installing the Modules

Installation Guide for the Avaya P550R, P580, P880, and P882 Multiservice Switches v5.3.1
Figure 1-5. Installing the Cable Management Bracket
3. Tighten the rack-mount pan head screws.
4. Thread the cables through the bracket to secure.
To install modules into the switch chassis:
1. Carefully remove each module from its shipping carton.
Leave the module wrapped in its antistatic bag.
* Note: Refer to
earlier in this chapter before removing the
module from the antistatic bag.
2. Carefully remove the module from the antistatic bag.
3. Open the Ejector Tabs (see
Unpacking and Installing
Cable Management
Preventing Electrostatic Discharge
Figure 1-6).
Bracket
1-7