Installing The Cable Management Bracket - Avaya P550R Installation Manual

Chapter 1

Installing the Cable Management Bracket

1-6
1. Place the system on a surface that supports at least 60 kg (130
lbs.) for a P550R/P580, or 80 kg (182 lb), for a P880/882.
2. Install the supplied rubber feet to the bottom of the switch,
placing the feet about 1.3 cm (1/2 in.) from each corner of the
unit in the square recesses provided
surface of any oils or residue before applying the feet.
Figure 1-4. Table Top Installation
3. Check that all of the pre-installed components are firmly
installed in the chassis. These include:
Modules
—
Power supply and fan assemblies
—
The Avaya P550R/P580/P880/P882 switch is shipped with a cable
management bracket. The bracket is installed on the right side of the
chassis.
To install the Cable management bracket:
1. Remove the plastic piece from the right side of the chassis.
2. Line the bracket up with the ball studs and screw holes and
push until it locks into place
Installation Guide for the Avaya P550R, P580, P880, and P882 Multiservice Switches v5.3.1
(Figure
Rubber Feet
(Figure 1-5).
1-4). Clean the