HP 260 G2 Maintenance And Service Manual page 66

Blank screen (no video).
Cause
Monitor is configured to use an input that is not active.
Blank screen and the power LED flashes Red five times, once every second, followed by a two second pause, and the computer
beeps five times. (Beeps stop after fifth iteration but LEDs continue flashing.)
Cause
Pre-video memory error.
Blank screen and the power LED flashes Red six times, once every second, followed by a two second pause, and the computer
beeps six times. (Beeps stop after fifth iteration but LEDs continue flashing.)
Cause
Pre-video graphics error.
Blank screen and the power LED flashes Red seven times, once every second, followed by a two second pause, and the computer
beeps seven times. (Beeps stop after fifth iteration but LEDs continue flashing.)
Cause
System board failure (ROM detected failure prior to video).
58 Chapter 6 Troubleshooting without diagnostics
Solution
To access Control Panel in Windows 7, click Start, and then
select Control Panel.
To access Control Panel in Windows 10, type control
panel in the taskbar search box, and then select Control
Panel from the list of applications.
2. Expand the Resolution box, and then use the sliding control
to reset the resolution.
Use the monitor's on-screen menu controls to select the input
that is being driven by the system. Refer to the monitor's user
documentation for more information on the on-screen controls
and settings.
Solution
1. Reseat DIMMs. Power on the system.
2. Replace DIMMs one at a time to isolate the faulty module.
3. Replace third-party memory with HP memory.
Replace the system board.
4.
Solution
For systems with a graphics card:
1. Reseat the graphics card (if applicable). Power on the
system.
2. Replace the graphics card (if applicable).
3. Replace the system board.
For systems with integrated graphics, replace the system board.
Solution
Replace the system board.