Know Your Machine - Nilfisk-Advance APC328 Instructions For Use Manual

revised 1/12
A - ENGLISH INSTRUCTIONS FOR USE

KNOW YOUR MACHINE

Operator Handle (1): Operator holds onto this handle to move the machine from one location to another.
Solution Tank Lid (2): This lid screws off so the tank can be fi lled. The solution fi ll hose is tethered to the lid, and hangs inside the arm of the
Operator Handle.
Maid's tote and Recovery tank lid (3): This removable container holds often-used items and has a handle for easy carrying. The recovery tank
lid sits under the maid's tote and covers the opening in the Recovery Tank. This is where the operator can access the tank to clean it and the ball
fl oat cage. The tank can be fl ushed out by running clean warm water into this opening and laying the open drain hose into a bucket or drain.
Recovery Hose (4): Waste water is picked-up through this hose.
Spray Hose (5): This hose delivers water from the machine to the cleaning tool.
Drain Hose (6): This hose is used to empty the recovery tank. NOTE: hold the end of the hose above the water level in the tank to avoid sudden,
uncontrolled fl ow of waste water when you remove the cap, then lower the hose slowly to control the rate of discharge.
Castors and Wheels (7): Castors pivot for ease of steering, and large back wheels make it easy to roll the machine from location to location.
Chemical Feed Lines (8): These clear tubes connect the cleaning chemical containers to the machine where the chemical can be siphoned into
the outlet water from the pump. Metering tips -- used to change the ratio of water to chemical -- are installed here.
Switch Plate (9): The machine's on/off switches for the vacuum and for the pump are located here and this is where the valve to change chemical
feeds is located.
Power Cord (10): The 25 ft. power cord connects to a power cord pigtail on the rear of the machine.
Chemical Container Holders (11): Two molded-in bottle holders for chemical jugs.
Tools & Accessories (12): Various accessories
can be stored on the machine.
4
1
10
2
3
12
6
8
11
7
9
5
7
A-4 APC328 - 56041948 5/10