Configuring Local Area Network - D-Link DIR-620 Quick Installation Manual

DIR-620

Configuring Local Area Network

1. Go to the Net / LAN page. If needed, change the IP address of the
router's LAN interface and the mask of the local subnet in the IP
Address and Netmask fields. To change the IPv6 address of the
router's LAN interface, deselect the DHCP PD checkbox in the IPv6
DHCP server section.
By default, the DHCP server of the router is enabled. In the DHCP
2.
server section, you can change the parameters of the DHCP server. If
you want to manually assign IP addresses to devices of your LAN, disable
the DHCP server (select the Disable value from the Mode drop-down
list).
3. By default, the DHCPv6 server of the router is enabled. In the IPv6
DHCP server section, you can disable the DHCPv6 server or change its
operating mode.
4. After specifying the needed parameters on the Net / LAN page, click the
Apply button.
Quick Installation Guide
36