Linksys LAPAC2600 User Manual page 93

System Summary
Device SKU
Firmware Version
Firmware
Checksum
Hardware Version
Local MAC
Address
Serial Number
Host Name
System Up Time
System Time
Power Source
LAG Status
The SKU is often used to identify device model number
and region.
The version of the firmware currently installed.
The checksum of the firmware running in the access
point.
The version of the hardware.
The MAC (physical) address of the wireless access
point.
The serial number of the device.
The host name assigned to the access point.
How long the system has been running since the last
restart or reboot.
The current date and time.
The power source of the access point. It can be Power
over Ethernet (PoE) or Power Adapter. When two power
sources are plugged in, Power Adaptor will be
displayed.
Indicates the status of LAG (Link Aggregation). It can
be "Inactive" or "Active"
When LAG is inactive, only one Ethernet port
•
works at a given time.
LAG only works when link speed and duplex of
•
the two Ethernet ports are the same and duplex
must be Full. LACP does not support half-
duplex.
LAG is based on 802.3ad LACP (Link
•
Aggregation Control Protocol) so it works only
when link ends of the two Ethernet ports of the
Access Ports also support 802.3ad LACP and
enable it.
93