Installations And Connections - Panasonic BM-ET500 Operating Instructions Manual

INSTALLATIONS AND CONNECTIONS

WARNING
The installation described in these figures should be made
by qualified service personnel or trained system installers.
Cautions:
• This system must be installed within the protected
promise in accordance with the National Electrical
Code (NFPA70), and the local authorities having juris-
diction.
• Attach this unit to a flat wall with the supplied mounting
bracket. After the installation, secure the unit to prevent
dropping.
I Caution on Installation
Secure the unit with the supplied mounting bracket to pre-
vent vibration, dropping and injury.
Notes:
• Keep the unit:
in the temperature between 0 °C and 40 °C {between
•
32 °F and 104 °F} and the humidity between 30 % and 80 %.
Top View
Coaxial cable (BNC)
BM-ET500
(For
enrollment)
General-purpose
power supply *
(24 V DC)
Administration PC*
* The use of the Administration PC was not evaluated by UL.
* The use of electric lock was not evaluated by UL.
* The use of door control box was not evaluated by UL.
* General-purpose power supply must be a UL Listed access control power limited device.
Keep this area free
from obstructions
400 mm {16 in.} 900 mm {35 in.}
1 300 mm {51 in.}
System Instruction (Maximum System)
OK
NG
Camera 3
LAN
• Keep the unit away from:
direct sunlight or light reflection.
•
incandescent or halogen lighting.
•
places where shadow appear over the front panel.
•
noise. (for example, places near air conditioners or ven-
•
tilators)
electricity.
•
outdoor places.
•
vibration. (It may cause invalid recognition or injury.)
•
• Do not place anything inside the space described in
the illustration.
• This unit is for indoor use only.
• This unit must be mounted horizontally on the wall.
• Determine the optimum mounting height. The recom-
mendation is between 1.38 m {54 in.} and 1.5 m {60 in.}
for enrollment/recognition effectiveness.
• Mount the bracket on the wall. Be sure to provide
access for video control and DC power from the control
unit.
Side View
80 mm {3 in.}
400 mm {16 in.}
Coaxial cable (BNC)
Camera power cable
BM-ED500
POWER ALARM S3 S2 S1
Camera 1
Camera 2
Wiegand
or RS-485
Door control box* Access server*
Keep this area free
from obstructions
900 mm {35 in.}
1 300 mm {51 in.}
Floor
OK
NG
BM-ET500
(For recognition)
OK
NG
BM-ET500
(For recognition)
Electric lock*
Electric lock*
In the case of Wiegand / RS-485 use
11