Panasonic AJ-SDC915 Operating Instructions Manual page 91

Setup Card Operations
Protecting stored data
If the setup card's WRITE PROTECT switch is set to ON, data is not rewritten even if the UP
button is pressed in step 7.
When data is not written
If the following error messages appear when the UP button is pressed in step 7, the data is not
written.
Data writing error messages
Error message
NO CONFIG The setup card is not
formatted.
NO CARD A setup card is not
inserted.
WRITE PROTECT The write protect switch on
the side of the card is set
to ON.
ERROR Data cannot be written on
the card.
Condition
– 91 –
Set to ON.
Countermeasure
Format the card.
Insert a card.
Set the write protect switch
on the side of the card to
OFF.
The card may be
defective. Replace the
card.