Panasonic AJ-SDC915 Operating Instructions Manual page 18

Digital camera/vtr dvcpro 50
Hide thumbs Also See for AJ-SDC915:
Table of Contents

Advertisement

Controls and Their Functions
Shooting (Recording)/Playback Function Section (4)
Super gain: When 30 dB is allotted to the SUPER IRIS button, DTL and other menu settings cannot be performed for this
30 dB.
VTR START button
When this pressed, recording commences; when it is pressed again, recording stops. This
button has the same function as the VTR button on the lens side.
VTR SAVE/STBY (tape protection) switch
This selects the power supply status while the VTR recording is temporarily stopped (REC
PAUSE).
SAVE: This is the tape protection mode. The cylinder is stopped in the half-loading status.
Compared with the STBY position, less power is consumed and the unit can be
operated longer using the battery. It takes longer for recording to commence after
the VTR START button
sition.
When the switch is set to this position, the VTR SAVE lamp inside the viewfinder
lights.
STBY: Recording commences immediately when the VTR START button is pressed.
|Note{
This unit will automatically go into SAVE mode when the designated time for standby (STBY)
condition is exceeded. To return to standby mode, press the VTR SAVE/STBY switch once to
select SAVE mode, then once again to return to STBY mode.
MODE CHECK button
While this button is kept depressed, the camera's setting status is displayed in the viewfinder. It
does not affect the camera's output signals.
SUPER GAIN button (inside sliding cover)
The super gain mode is forcibly established when this button is pressed, and each time the
button is pressed when all the super gain values have been set using "SUPER GAIN" on the
MAIN menu 2 of 4 screen, the gain is switched by one level in the following sequence: 30 dB>
36 dB>OFF>30 dB, etc. However, the DTL and other menu settings cannot be performed.
SUPER IRIS button (inside sliding cover)
This is used when backlight compensation (or the super black functionF
When it is pressed, the switch settings are displayed inside the viewfinder for 3 seconds. When
it is pressed again, backlight compensation (or the super black functionF
F
1
See Main Menu Screen 2 of 4 on page 126 for details on the super black function.
– 18 –
is pressed in the SAVE position than in the STBY po-
1
) is to be provided.
1
) is released.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Aj-sdc915p

Table of Contents