Setting The Gain Selector Value - Panasonic AJ-PD900WP Operating Instructions Manual

Adjustments and Setup During Recording

Setting the Gain Selector Value

When shooting in locations without sufficient brightness, bright images can be obtained by rais-
ing the gain. However, care should be taken as raising the gain also increases the noise.
The gain value for the image amplifier is selected by the GAIN switch. The gain values corre-
sponding to the L, M and H positions of the GAIN switch are set at the MASTER GAIN page of
the setting menu.
Setting the gain selector value
1
Set the MENU SET/OFF switch to SET.
The page on which the previous setting menu operations were completed appears on the
viewfinder screen.
(When the menu is used for the first time, the first page appears.)
2
Press the PAGE button to display the SETTING (LOW/MID/HIGH) page shown below.
(This operation can also be performed using the PAGEoUP/DOWN function.)
3
Press the SHIFT/ITEM button repeately to move the cursor to the MASTER GAIN position.
4
Press the UP or DOWN button to set the gain value.
The gain value can be set freely regardless of size from among p3, 0, 3, 6, 9, 12, 15, 18,
21, 24 and 30 dB.
When resetting the gain values to the settings when shipped from the factory (LOWr0 dB,
MIDr9 dB, HIGHr18 dB), select MENU INIT. at the DATA RESET page of the setting
menu and press the UP or DOWN button.
5
When menu operations have been completed, set the MENU SET/OFF switch to OFF.
The setting menu disappears from the viewfinder screen and the displays indicating the
unit's current status appear at the top and bottom of the viewfinder screen.
- LOW SE T T I NG (
MAS T ER GA I N
¢
H . DT L L EVE L
V . DT L L EVE L
DT L COR I NG
H . DT L FREQ .
V . DT L FREQ .
DARK DT L
L EVE L DEPEND : 0 1
MAS T ER GAMMA : 0 . 4 5
B L ACK S TRE TCH : OF F
MA TR I X T AB L E : A
– 64 –
1 6 E 9 / P
) -
: 0 d B
: 1 2
: 1 4
: 0 2
: 0 4
: P
: 0 0