Disassembly - Pioneer AVIC-F910BT Service Manual

1

7. DISASSEMBLY

QQ
3 7 63 1515 0
NOTE) While the photograph shown is slightly different from this model in shape, the disassembly
procedure is the same.
A
Removing the Case (Fig.1)
1
Remove the two screws and then remove
the Case.
Note)
To remove the screws, use jig No. GGK1068.
B
Removing the DVD Mechanism Module (Fig.2)
1
Remove the four screws.
2 Disconnect the connector and then
remove the DVD Mechanism Module.
C
TE
L 13942296513
D
When unplugging the cord assy, make sure to use jig GGF1539.
If the antenna cable is directly unplugged without using jig GGF1539, you might damage your fingertip or fingernail.
- How to Remove the Cord Assy
When unplugging cord assy, hook the point of jig GGF1539 on the lid of cord assy and vertically draw out
along with the engagement axis of connector.
E
- How to Attach the Cord Assy
www
For inserting cord assy, adjust cord assy with the engagement axis of connector and insert it as vertically
as possible.
Do not insert the cord assy in extreme slant, as the connector might suffer damage.
F
104
1
http://www.xiaoyu163.com
2
GGF1539
x ao
y
. i
AVIC-X910BT/XS/UC
2
http://www.xiaoyu163.com
3
8
Case
1
1
2
1
Q Q
3 6 7 1 3
DVD Mechanism Module
Cord Assy
Connector
u163
.
3
4
2 9 9 4 2 8
1
1
1
1 5 0 5 8 2 9 9 4
m
co
4
9 9
Fig.1
2 8 9 9
Fig.2