Table of Contents
Advertisement
4.2.6 INSPECT/TEST FUEL SUPPLY SYSTEM
Every three months (or 120 hours), an authorized
operator should inspect and test the fuel supply sys-
tem, as well as all fuel system connections. All con-
nections must be tight and in good condition. A loose
fuel system line may show no signs of leakage, but
may draw air into the system causing rough opera-
tion and starting difficulties. Any defective or leaking
component should be repaired or replaced immedi-
ately by an Authorized Service Technician.
4.3
REPAIR PARTS
The latter portion of this manual consist of exploded
views, parts lists and electrical data pertaining to this
generator set. The parts lists consist of (a) an item
number, (b) a part number, (c) the quantity required,
and (d) a description of the part. The item number
corresponds to an identical number on the exploded
view drawing.
14
Section 4 – Maintenance
Standby Generator Set
4.3.1 HOW TO ORDER PARTS
To order a replacement part, locate the part in the
applicable exploded view. Contact an Authorized
Service Dealer (call 800-333-1322 to locate one in the
area) and provide the following information:
• The generator model number.
• The generator identification code, which indicates
the specific generator assembly for each unit.
• The part number and corresponding description
from the applicable parts list in this manual.
• The applicable exploded view "Group" letter (A-H)
and drawing number (five-digit number), which
can be found on the exploded view drawing.
In most cases, obtain repair parts by providing
the Authorized Service Dealer with the data label
information and a description of the required part.
If unable to locate either the data label or the con-
struction document, describe the part needed and
provide the unit's model number. This number
can be found on the DATA LABEL attached to the
generator's lower connection box.
NOTE:
Advertisement
Table of Contents
