Table of Contents
Advertisement
34
Picture ID Settings
Picture ID is used to change the settings of a specific
set (display) using a single IR receiver for multi-vision.
Communication is possible between a monitor with
an IR receiver and other monitors using RS-232C
AUDIO
cables. Each monitor is identified by a Set ID. If you
(RGB/DVI)
RS-232C OUT
assign the Picture ID using the remote control, only
RS-232C IN
displays with matching Picture ID and Set ID can be
REMOTE
CONTROL IN
controlled remotely.
1
Assign the Set ID to the installed monitors as
shown below.
IR and Light Sensor
RS-232C Cables
2
Press the red ON button on the remote control to
assign the PICTURE ID.
3
Assign the Set ID to the selection of your choice.
A set with a different Set ID from the Picture ID
•
cannot be controlled by IR signals.
RS-232C OUT
RS-232C OUT
RS-232C IN
RS-232C IN
PICTURE ID ON [2]
NOTE
If Picture ID is set to 2, only the upper right
•
monitor, which has a Set ID of 2, can be controlled
by IR signals.
If you press the green OFF button for PICTURE ID,
•
the Picture IDs for all monitors are turned off. If you
then press any button on the remote control, all
monitors can be controlled by IR signals regardless
of Set ID.
With PICTURE ID ON, you can only increase the
•
Picture ID by 1. You cannot decrease it.
Advertisement
Table of Contents
