Preparations; Connection; 5.1-Channel Speaker Layout; Connecting Speakers - Yamaha BRX-610 Owner's Manual

PREPARATIONS

5.1-channel speaker layout

FL
SL
Front speakers (FR and FL):
For the front channel sound (stereo sound) and effect
sound.
Center speaker (C):
For the center channel sound (dialogue, vocals, etc.).
Surround speakers (SR and SL):
For effect and vocal sound from surround channel. The
surround back channel sound is output from the surround
speakers when a disc which has 7.1- or 6.1-channel
sounds is played back.
Subwoofer (SW):
For low-frequency effect (LFE) sound and bass sound
from front and surround channels.

Connecting speakers

Connect speakers to the unit.
When you are using a subwoofer speaker, check if it is
active (built-in amplifier, with power cable) or passive
(not built-in amplifier, without power cable). The cable
used for connecting a subwoofer differs depending on the
subwoofer type.
After connecting the speakers, setting according to the
speaker type (size, number of available speakers, etc.) is
required. See page 40 for speaker setting.

CONNECTION

FR
C
SW
SR
Notes
• Disconnect the power plug before connecting speakers.
• When connecting speakers, use speakers having more than 6Ω
impedance for the front, center and surround speakers, and 4Ω
to 6Ω impedance for a passive subwoofer. For an active
subwoofer (built-in amplifier), you need not be concerned about
impedance.
• When connecting an active subwoofer (built-in amplifier), be
sure turn it off before connecting to the unit.
• Be careful that the core of the speaker cable does not touch
anything or come into contact with the metal areas of the unit.
This may damage the unit or the speakers.
■ Necessary cables (not supplied)
When the subwoofer is passive:
• Speaker cables × 6
+
–
When the subwoofer is active:
• Speaker cables × 5
+
–
• Monaural pin cable (for subwoofer) × 1
The rear panel of this unit
(when the subwoofer is passive)
+
–
+
–
11
En