Table of Contents
Advertisement
Installation
3. Installing the pan-tilt head
w Pan-tilt head mounting conditions
Pan-tilt head mass (weight)
Mounting specifications
Compatible cameras
Camera mass (weight)
Camera anti-drop measures Wire provided used for mounting
Compatible lenses
Lens mass (weight)
Cable mass (weight)
Total mass (weight)
Mounting the pan-tilt head
Recommended screws
Hexagon head bolts (M6)
w Parts to be provided by the customer for installation
When installing the pan-tilt head, check the "Pan-tilt head mounting conditions" described
above, and be sure to follow the instructions below.
A hole for the drop prevention underneath support plate is provided on the bottom of the
pan-tilt head separately from the holes used to mount the pan-tilt head.
M8 holes (for mounting the
underneath support plate)
Holes or mounting the pan-tilt
head (4 locations)
Check the positions and dimensions of the mounting holes above, and check which is the base
connector rear panel side. Then decide in which direction the pan-tilt head is to be mounted, and
fashion the anchors or provide the hangers.
(Be sure to ask your dealer to install the unit.)
Approx. 3.5 kg (7.7 lbs)
Installation on the ceiling or stand-alone installation
AW-E350, AW-E650, AW-E655, AW-E750, AW-E860, AW-HE870,
AK-HC1500, AK-HC1800
Approx. 1.5 kg (3.3 lbs) max.
AW-LZ16MD55, AW-LZ16MD73, AW-LZ17MD9A, AK-LZ20M85,
HAs18x7.6BMD, ZA12x4.5B(E)MD, ZA17x7.6B(E)MD, ZA22x7.6B(E)MD,
XA20sx8.5BMD, HJ22ex7.6B ITS, HJ17ex7.6B ITS, KJ22ex7.6B ITS,
KJ17ex7.7B ITS, KJ13x6B KTS
Approx. 2.0 kg (4.4 lbs) max.
Approx. 0.3 kg (0.7 lbs)
Approx. 7.5 kg (16.5 lbs)
No. of screws
4 pcs
<Positions and dimensions of the mounting holes>
Drop prevention
underneath support plate
Mounting the plate
Recommended screw
Hexagon head bolt (M8)
113 mm (4-7/16˝)
74 mm
(2-15/16˝)
Base connector rear panel side
of pan-tilt head
– 20 –
No. of screw
1 pc
4-M6 holes (for mounting
the pan-tilt head)
M8 hole (for mounting
the underneath support
plate)
Advertisement
Table of Contents
