Motion picture playback on a PC
■
Use "QuickTime" (for Windows 2000/XP/
Vista) in the supplied CD-ROM when you
play back motion pictures recorded on this
camera on your PC.
•
Download [QuickTime6.5.2 for Windows]
from the following website and install
it on your PC when you use Windows
98/98SE/Me.
http://www.apple.com/support/
downloads/quicktime652forwindows.html
•
The software is a standard Macintosh
feature.
Folder composition
■
Folders appear as follows.
DCI M
•
Built-in
memory
•
Card
MIS C
1 Folder number
2 File number
3 JPG : Pictures
MOV : Motion pictures
MISC: Folder containing files with following
settings
DPOF print
Favourite
•
This unit stores up to 999 picture files in
each folder. A new folder is created after
this maximum is reached.
•
To reset file and folder numbers, use
[NO.RESET] in the setup menu.
Connecting to other equipment
100_PANA
100_PANA
1
P1000001.JPG
2 3
P1000002.JPG
P1000999.JPG
101_PANA
999_PANA
(P23)
Conditions under which a different
■
folder number is used
In the following cases, the picture is
not recorded in the same folder as the
previously recorded picture. It is recorded
in a folder with a new number.
•
The folder containing the picture you
just shot had a file numbered 999 in it
(example: P1000999.JPG).
•
When the card just recorded to contains,
for example, a folder with the number
100 (100_PANA) in it and that card is
removed and replaced with a card that
has a folder with the number 100 in it
recorded by a camera from a different
maker (100XXXXX, with XXXXX being
the name of the maker) and then a
picture is recorded.
•
You start shooting again after using
[NO.RESET] in the setup menu. (It
is recorded to a new folder that has
a number following on from the one
previous. You can also reset the folder
number to 100 by using [NO.RESET]
immediately after formatting the card
when there are no folders or pictures on
the card.)
Connection in the PTP mode
■
If the OS is "Windows XP", "Windows
Vista" or "Mac OS X", you can connect
in PTP mode if you set the camera to
[PictBridge (PTP)] and press [MENU/SET]
after connecting the USB cable.
•
You can only load pictures from the
camera and cannot write them on the
card or delete them.
[However, you can connect in MTP mode
on Windows Vista, instead of PTP. Then,
you can format or delete the data on
the card. (DMC-LZ10GC/DMC-LZ10PL/
DMC-LZ8GC/DMC-LZ8PL)]
•
When there are 1000 or more pictures on
a card, the pictures may not be imported.
- 101 -