Panasonic KX-TD1232NE User Manual page 230

6.1 Troubleshooting
Problem
"PS NO CONNECTED" is displayed.
"REGISTER UNIT" is displayed.
"NO SERVICE" is displayed.
You cannot store a phone number and
name in the directory.
The alarm sounds after pressing the
Redial button.
" " flashes or beeps tones sound
every 5 seconds during a
conversation.
You charged the batteries fully, but
" " flashes.
The PS stops working during
operation.
Handover does not work.
The display does not show a strong
radio signal " " even though you
are near the CS.
The alarm sounds during a
conversation while receiving a weak
radio signal " ".
230
The power switch is set to OFF.
•
Turn it ON. ( 5.2.1 Before Operating the DECT
Portable Station Button Descriptions)
• The PS is out of range.
Move closer to the CS.
• The radio channel is busy or a radio communication
error occurred.
Try again later.
• The PS is not registered in the system.
Consult your dealer.
• The PS is out of range.
Move closer to the CS.
• Your entry exceeds the maximum digits or
characters.
• Do not pause for over 30 seconds while
programming.
A number is not saved in the Call Log.
•
• The battery is low.
Charge the batteries fully. (
the DECT Portable Station Battery Charge)
Clean the charge contacts and charge again.
It is time to change the batteries. Please purchase new
batteries.
Turn the power switch OFF and ON. Then try again.
( 5.2.1 Before Operating the DECT Portable Station
Button Descriptions)
Re-insert the battery and try again. (
Operating the DECT Portable Station Battery Charge)
• You moved to a busy CS or are out of range.
• You moved while not having a conversation (e.g.,
while hearing a busy tone).
• The radio channel is busy or a radio communication
error occurred.
• Normally, the PS user can make a call even with a
" " status. In this case, the current linked CS is still
connected even though another CS is closer.
The radio signal is weak.
•
Move closer to the CS.
Remedy
5.2.1 Before Operating
5.2.1 Before
Appendix