Periodic Maintenance; Troubleshooting - Electrolux EGL6282NOX User Manual

Hide thumbs Also See for EGL6282NOX:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 47
2.
Clean the appliance with a damp
cloth and some detergent.
3.
At the end rub the appliance dry
with a clean cloth.
The stainless steel can become tarnished
if it is too much heated. Refer to this you
must not cook with potstones, earthen-
ware pans or cast iron plates. Do not use
aluminium foil to prevent damage the top
during operation.
6.1 Cleaning the electric
hotplate
Clean the appliance after each use.
Always use cookware with clean bottom.
WARNING!
Before any maintenance or clean-
ing can be carried out, you must
disconnect the hob from the elec-
tricity supply.
The hob is best cleaned while it is
still warm, as spillage can be re-
moved more easily than if it is left
to cool.
WARNING!
Sharp objects and abrasive clean-
ing agents will damage the appli-
ance.
For your safety, do not clean the
appliance with steam blasters or
high-pressure cleaners.
Scratches or dark stains have no
effect on how the appliance oper-
ates.

7. TROUBLESHOOTING

There is no spark when
lighting the gas.
Problem
Removing the dirt:
1.
2.
3.
4.
6.2 Cleaning of the spark plug
This feature is obtained through a ceramic
ignition candle with a metal electrode.
Keep these components well clean to
prevent difficult lighting and check that the
burner crown holes are not obstructed.

6.3 Periodic maintenance

Periodically speak your local Service
Force Centre to check the conditions of
the gas supply pipe and the pressure ad-
juster, if fitted.
Possible cause
• There is no electrical
supply.
Use the fine scouring powder or a
scouring pad to remove the dirt.
Clean the appliance with a damp
cloth and some detergent.
Heat the hotplate to a low tempera-
ture and leave to dry.
To maintain the hotplates, wipe the
plates with a drop of olive oil on a
kitchen towel to prevent rust.
For stainless steel edges of the
hob use cleaner for stainless steel.
The stainless steel edge of the
plate can be slightly discoloured
as a result of the thermal load.
Remedy
• Make sure that the ap-
pliance is connected
and the electrical sup-
ply is switched on.
• Do a check of the fuse.
If the fuse is released
more than one time, re-
fer to a qualified electri-
cian.
ENGLISH
55

Advertisement

Table of Contents
loading

Table of Contents