Chapter 4: Calibration
Depth units
Speed and log units
Log calibration
2. Use the depth key to increase or speed to decrease the displayed
offset.
3. Press depth and speed together momentarily to exit edit mode.
Actual
Water
Depth
Actual
Water
Depth
The available depth units are metres or feet. These units are toggled
with the depth or speed key.
The available speed and log units are Kmh, Mph, Kts, SM and NM.
These units are toggled with the depth or speed key.
To ensure correct speed and log values are displayed, a correction
factor must be entered at the log display.
The correction factor = Charted distance ÷ Average Distance.
The charted distance is the distance between two charted objects.
Ideally, this should be about 1 nm.
Biducer
Negative Offset
D1762-2
Biducer
Positive Offset
D1766-2
17