Table of Contents
Advertisement
Performance in the Score Mode
Press an LED button briefly to play the sound assigned to it. At the
same time the lights will flash outward from the played sound. If you
hold the LED button a bit longer it will remain lit and will become an
active note that will play repeatedly. Press and hold an active note to
de-activate it.
The loop indicator will be continuously cycling from the left to right
edge of the LED button matrix. Active notes will play when the loop
indicator coincides with their positions on the matrix.
Press the [CLEAR] button to de-activate all active notes.
=
Active notes will play and flash when
the loop indicator passes over them.
Master Volume Adjustment
To adjust the overall volume of the TENORI-ON, rotate the jog dial
while holding the [R4] function button. The volume setting will appear
in the LCD display.
This volume setting is temporary. Refer to page 43 in the TENORI-ON Manual (pdf file) for
=
details on setting the overall "hardware" volume.
Increase
Volume
Jog Dial
Decrease
Volume
Pausing Loop Playback
Press the [OK] button while the highlighted "STOP" indicator in the
lower right corner of the LCD display is shown to temporarily pause
[CLEAR] Button
loop playback. The loop indicator will stop at the position at which
the [OK] button is pressed, and the highlighted "STOP" indicator will
change to "START." Press the [OK] button a second time and loop
playback will resume from the point at which it was paused.
V�l���
∞
������01�
:
96
M�s���
: 127
Current loop indicator position.
Press and hold
the [R4] button.
Layer Volume
Master Volume
[OK] Button
07
Advertisement
Table of Contents
