Controls And Functions - Yamaha AUDIOGRAM 6 Owner's Manual

Controls and Functions

t
y
u
i
o
!0
1
MIC/INST Input Jack
Microphones and instruments such as guitars can be
connected here using XLR or phone jack cables. Set
5
the MIC/INST switch
the type of device connected.
XLR-type
You can directly connect an electric guitar or
NOTE
bass without the need for a separate DI
(Direct Injection) box or amp simulator.
2
LINE Input Jacks (L (MONO)/R)
These inputs are intended mainly for use with instru-
ments and equipment having stereo outputs, such as a
synthesizer or CD player.
If you connect to the L (MONO) jack only, the AUDIO-
GRAM will recognize the signal as monaural and will
send the identical signal to both the L and R jacks.
Phone-type
q w
to MIC or INST according to
Phone-type
!6
e r
3
STEREO OUT Jacks
These output the mixed signal from channels 1 to 5/6.
The output level can be adjusted using the MASTER
LEVEL control. These jacks would typically be con-
nected to monitor speakers (powered speakers).
4
PHONES Jack
Connects a pair of headphones to this jack. The
PHONES jack outputs the same signal as the STEREO
OUT jacks.
5
MIC/INST Switch
Set this switch according to the type of device con-
nected. Select MIC ( ) if a microphone is connected,
or INST ( ) if an electric guitar or bass is connected.
NOTE If a device is not connected to the MIC/
INST jack, set this switch to MIC (
Otherwise noise may occur.
6
GAIN Control
Adjusts the input signal level. To achieve the best bal-
ance between S/N ratio and dynamic range, adjust the
level so that the input channel PEAK indicator
only occasionally and briefly on the highest input tran-
sients.
AUDIOGRAM 6 Owner's Manual
!1
!2
!3
!4
!5
).
9
lights
15