Care & Cleaning - Panasonic CU-UE12JKE Operating Instructions Manual

Hide thumbs Also See for CU-UE12JKE:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Care & CLeaninG
Care & CLeaninG
• Switch off the power supply and unplug before cleaning.
• Do not touch the aluminium fin, sharp part may cause injury.
Caution
wASHING INSTRUCTIONS
• Do not use benzene, thinner or scouring powder.
• Use only soap ( pH7) or neutral household detergent.
• Do not use water hotter than 40°C.
ALUmINIUm fIN
AIR fILTERS
• Clean the filters regularly.
• Wash/rinse the filters gently
with water to avoid damage to
the filter surface.
• Dry the filters thoroughly under
the shade, away from fire or
direct sunlight.
• Replace any damaged filter.
note :
• Take illustrations of CS-UE12JKE for example. Care & Cleaning method for CS-UE9JKE is identical.
fOR SEASONAL INSPECTION AfTER EXTENDED
NON-USE
• Checking of remote control batteries.
• No obstruction at air inlet and air outlet vents.
• After 15 minutes of operation, it is normal to have the
following temperature difference between air inlet and air
outlet vents:
Cooling: ≥ 8°C
fOR EXTENDED NON-USE
• Activate heat mode for 2~3 hours to thoroughly dry the unit.
• Turn off the power supply and unplug.
• Remove the remote control batteries.
6
Remove
Heating: ≥ 14°C
HintS
• Clean the filter regularly for best performance and to
reduce power consumption.
• Please consult your nearest dealer for seasonal
inspection.
note :
• If chemical cloth is used to wipe the unit, instruction for
the cloth should be followed.
INDOOR UNIT
Wipe the unit gently with
a soft, dry cloth.
NON SERvICEAbLE CRITERIAS
TURN OFF POWER SUPPLY AND UNPLUG then CALL
Authorized Distributor under the following conditions:
• Abnormal noise during operation.
• Water/foreign particles have entered the remote control.
• Water leaks from Indoor unit.
• Circuit breaker switches off frequently.
• Power cord becomes unnaturally warm.
• Switches or buttons are not functioning properly.
• The timer indicator blinks and the unit can not be operated.
fRONT PANEL
Remove front Panel
• Raise and pull to
remove the front panel.
• Wash gently and dry.
Close front Panel
• Press down both ends
of the front panel to
close it securely.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cu-ue9jkeCs-ue12jkeCs-ue9jke

Table of Contents