Connections; System Connections - Panasonic WV-BM1910 Operating Instructions Manual

CONNECTIONS

Power Cord
1. Keep the Power ON/OFF switch of the camera in
the OFF position during installation.
2. Connect the Power Cord to a grounded electrical
outlet.
Video Cable
Use a 75 Ω coaxial cable (RG-59, RG-59A/U, RG-
59B/U, RG-59/U, RG-6/U, or RG-11/U).
1. Up to 10 monitors can be hooked up in this
configuration before signal loss occurs. Total cable
length should not be longer than 150 meters (500
feet).

SYSTEM CONNECTIONS

1. Single Monitor Connection
TV Camera
Coax.
Cable
• Connect the Video Input Connector (VIDEO IN) on
this monitor to the Video Output Connector of the
video source with a coaxial cable.
WV-BM1910
VIDEO
OUT IN
OFF ON
-4-
2. Wiring Precautions :
Do not bend the coaxial cable into a curve whose
radius is smaller than 10 times its diameter.
Never staple coaxial cables, not even with circular
staples.
Never crush or pinch the cable.
All of the above will change the impedance of the
cable and cause poor picture quality.
2. Multiple Monitor Connection
TV Cameras
Coax.
Cable
• Connect the Video Input Connector (VIDEO IN) on
this monitor to the Video Output Connector of the
video source with a coaxial cable.
• Connect the Video Output Connector (VIDEO OUT)
on this monitor to the Video Input Connector
(VIDEO IN) on the second monitor with a coaxial
cable.
• Complete the connections of all monitors in the
system according to the above procedure.
Video Switcher
VIDEO
OUT IN
First Video
Monitor
VIDEO
OUT IN
Last Video Monitor