Audiovox Prestige Platinum APS-510 Installation Manual page 2

Fifth Press and release the valet switch
Press transmitter Lock button to change
or
Sixth Press and release the valet switch
Press transmitter Lock button to change
or
Seventh Press and release the valet switch
Press transmitter Lock button to change
or
Eighth Press and release the valet switch
Press transmitter Lock button to change
Press transmitter lock button to change
or
Ninth Press and release the valet switch
Press transmitter Lock button to change
Press transmitter Lock button to change
or
Tenth Press and release the valet switch
Press transmitter Lock button to change
or
EleventhPress and release the valet switch
Press transmitter Lock button to change
or
Twelfth Press and release the valet switch
Press transmitter Lock button to change
Press and release the valet switch
or
Turn ignition key off
Note: Once you enter the feature programming mode, do not allow more than 15 seconds to pass between steps,
or the programming will be terminated.
Note: This system allows the transmitter to be programmed for single button lock/unlock or separate
button lock/unlock. The receiver is set up as follows:
Channel #1
Channel #2
Channel #3
Channel #4
Channel #5
During the program routine, if a transmitter button is programmed into receiver channel 2, then the unit will
always have separate lock/unlock from that transmitter.
If during the program sequence receiver channel 1 is programmed, and received channel 2 is skipped over,
as indicated in the transmitted program guide, then the unit will operate as a single button lock/unlock unit
from that transmitter.
It is possible to have one transmitter programmed for single button lock/unlock, and one transmitter pro-
grammed for separate button lock/unlock if the customer so desires.
If you inadvertently incorrectly program the transmitter, please read the information on re-prioritizing found
in the transmitter programming guide.
Control Module:
Select a mounting location inside the passenger compartment ( up behind the dash ), and secure using the
two screws provided. The control module can also be secured in place using cable ties.
INSTALLATION OF MAJOR COMPONENTS
= Lock/Unlock/Unlock 2 &Panic
= If Programmed, Unlock/Unlock 2 & Panic
= Channel 3 & Alternate Channel 3
= Channel 4 Output
= Channel 5 Output (If so Equipped)
Page 2
2 chirps = active locks
1 chirp = passive locks
2 chirps = active arming
1 chirp = passive arming
2 chirps = hardwire
1 chirp = voltage sense
1 chirp = siren and horn output
2 chirps = siren output only
3 chirps = horn output only
2 chirps = horn chirp output 16mS
3 chirps = horn chirp output 30mS
1 chirp = horn chirp output 10 mS
2 chirps = valet switch override operation
1 chirp = custom code override operation
2 chirps = 2 step unlock off
1 chirp = 2 step unlock on
2 chirps = chirp delete from transmitter inactive
1 chirp = chirp delete from transmitter active
Exit program mode
Exit program mode