Avoiding Crossing Remote Control Signals When Using Multiple Yamaha Receivers; Changing Tv Format; Removing Hdmi Video Output Up-Scaling Limits - Yamaha RX-V767 Owner's Manual

MAIN ZONE 2
CODE SET o
Avoiding crossing remote control
RECEIVER
SOURCE p
signals when using multiple
HDMI
1 2 3 4
AUDIO
Yamaha receivers
5 V-AUX 1 2
AV
1 2 3 4
5 6 MULTI DOCK
HDMI OUT
TUNER PHONO
REMOTE ID -ID1
FM AM
PRESET TUNING
INFO MEMORY
The remote control of the unit can only receive signals
ENHANCER SUR. DECODE
from a receiver which has an identical ID (remote
MOVIE MUSIC
SLEEP PARTY STRAIGHT PURE DIRECT
control ID). When using multiple Yamaha AV receivers,
SCENE
you can set each remote control with a unique remote
BD
TV CD RADIO
DVD
control ID for its corresponding receiver.
OPTION
ON SCREEN
On the contrary, if you are setting the same remote
control ID for all receivers, you can use one remote
ENTER VOLUME
control to operate 2 receivers.
RETURN
DISPLAY
TOP
POP-UP
MUTE
ID1 (Default)
MENU MENU
REC
ID2
1 2 3 4
m
5 6 7 8
9 0 10 ENT
ID1 is set for both remote control and receiver by
INPUT
default. To avoid crossing remote control, change the
MUTE
remote control ID for both remote control and
receiver.
m
Numeric keys
o
CODE SET
p
SOURCE/RECEIVER
■ To change the remote control ID
1
2
3
Receives the remote control signals set in
ID1.
Receives the remote control signals set in
ID2.
Extended functionality that can be configured as needed (Advanced Setup menu)
Perform each of the following steps within
1 minute. Settings will be automatically stopped if
more than 1 minute passes since the last operation.
To reset, repeat from step 1.
oCODE SET
Press using a pointed
object such as the tip of a ballpoint pen.
Press pSOURCE/RECEIVER.
Enter the desired remote control ID code.
To switch to ID1:
m
Enter "5019" using Numeric keys.
To switch to ID2:
m
Enter "5020" using Numeric keys.
Once the remote control code is registered successfully
p
SOURCE/RECEIVER will blink twice.
Registration successful: blinks twice
Registration failed: blinks 6 times
MAIN ZONE 2
CODE SET
SOURCE RECEIVER
HDMI
1 2 3 4
• If setup fails, repeat from step 1.
• Returns to ID1 after the remote control code is
initialized (☞p. 95).
SETUP

Changing TV format

TV FORMAT-NTSC
Change the color encoding format of OSD to PAL or
NTSC, to match the format used by the TV connected
via the HDMI OUT 1-2 or VIDEO (MONITOR OUT)
jack.
Removing HDMI video output up-
scaling limits
MON.CHK - YES
Removes the up-scaling limitation on video resolution
when this unit and a TV are connected via HDMI jacks.
If a resolution supported by the monitor cannot be
detected when configuring the up-scaling settings, this
setting will remove the output limitation.
YES (Default) Video output signals of a resolution not
supported by the TV will not be
transmitted.
SKIP This unit ignores the TV's support
capability and transmits input video
signals to the TV.
En
97