Advertisement
Changing the Massage Mode
•
The massage mode used can be switched via the controller.
• P ress once to
switch to
Press
.
knead A.
•
The mode can also be changed midway through a massage.
When the mode is changed, the new selected massage will start after all
the air has been released.
Massage Mode Descriptions
Massage Mode Descriptions
Knead A
•
A slow and thorough massage is given using an upward squeezing action on the selected part
of the body.
•
Recommended for people who are prone to swelling.
Knead B
•
Muscles are pleasantly loosened with rhythmical pressure.
•
Recommend for tired leg muscles from exercising, etc.
Combined
•
Fatigue is pleasantly relieved and blood circulation in the legs is promoted by a variety of
massage actions of varying rhythms, in addition to that of modes knead A and B above.
Adjusting the Intensity
•
The intensity of the massage can be adjusted in three steps.
•
One lamp lights up with each step adjusted.
Press
.
Intensity 3
Intensity 2
Intensity 1
GB7
7-8
• P ress a second
• P ress a third
• P ress a fourth
time to switch
time to switch
time to switch
to knead B.
to combined.
back to knead A.
Stronger
Weaker
AFTER COMPLETING THE MASSAGE
Disconnect the Power Plug.
•
When not in use for extended periods of time, please disconnect the power plug from the outlet as a
measure to save energy.
(Noise may be heard when operationally idle, as approx. 5 W of electricity are used even when not in operation.)
CAUTION
•
Unplug the power plug from the outlet when the unit is not in use.
Failure to observe this precaution may result in electrical fire due to deterioration of insulation caused by dust
and moisture.
•
Always hold the power plug, not the power cord, when unplugging from an outlet.
Failure to observe this precaution may result in electric shock or short-circuit.
Return the Massage Section to Its Original Position.
•
Pull the angle lock lever outward and return the massage section.
(See page GB5)
Return the Controller to the Holder.
•
Both the controller and the controller cord can be stored
in the holder on the underside of the unit.
•
Return the controller to the controller holder.
GB8
2008/02/21
22:03:30
Advertisement
