Table of Contents
Advertisement
Problem
Cause and Remedy
While programming or
•To answer the call, press [_
or _.
searching, the unit starts to
Start again from the beginning after
ring and stops the program/
hanging up.
search.
The unit does not display the
caller's name and/or phone
number.
• You do not subscribe to a Caller ID
service.
• Other telephone, equipment may be
interfering with your phone. Disconnect
it and try again,
• Other electrical appliances connected to
the same outlet may be interfering with
the Caller ID information.
• Telephone line noise may be affecting
the Caller ID information,
The handset display goes to
•Do not pause for over 60 seconds while
the standby mode while
searching.
viewing the Caller List.
When a second call is
received during a
conversation, the unit does
not display the new caller's
name and/or phone number.
• The line mode selection is incorrect.
See page 16.
• The caller requested not to send his/her
information. See page 34.
_LOCATOR/INTERCOM_ does
not function.
• The handset is too far from the base
unit.
• The handset is engaged in an outside
call or is viewing the Caller List/directory
list. Wait until the
IN USE/CHARGE/HOLD
indicator light
goes out.
You cannot redial by
pressing
(REDIAL/PAUSE/FU NOTION _.
elf the last number dialed was more than
32 digits long, the number will not be
redialed correctly.
eAccess numbers entered after pressing
ITONE/will not be included when
redialing,
7/
Advertisement
Table of Contents
