Tripp Lite BHDBT-K-E3SI-ER Owner's Manual page 7

Installation
1. Make sure the HDMI and RS-232 serial source is powered off.
2. Connect the HDMI source to the HDMI input port on the local transmitter unit.
3. Connect RS-232 serial DB9 cable (not included) to the RS-232 port on the local
transmitter unit, then connect to computer.*
4. If you are using a remote control on the transmitter side of the installation to
control a device on the receiver side (such as a TV), connect the IR-IN cable (with
red 3.5 mm connector) to the IR-IN port on the local transmitter unit.
Note: The IR-IN unit accepts a signal from a remote control and sends it to a device that is
controlled on the other end of the installation. Position the IR-IN unit in an unobstructed area
that can easily accept a remote control signal.
5. If you are using a remote control on the receiver side of the installation to control a
device on the transmitter side (such as a Blu-ray player), connect the IR-OUT cable
(with green 3.5 mm connector) to the IR-OUT port on the local transmitter unit.
Note: The IR-OUT unit receives the signal from the remote control on the other end of the
installation and sends it to the device being controlled. Locate the IR-OUT unit in an area close
to the remote-controlled device (e.g., Blu-ray player, TV).
6. Connect the three 10/100 Ethernet ports on the transmitter unit to your devices
(e.g., Blu-ray player, cable box, etc.) and/or a LAN.*
7. Connect the external power supply to the local transmitter unit and plug it into a
Tripp Lite Surge Protector, Uninterruptible Power Supply (UPS) or Power Distribution
Unit (PDU).
8. Connect the RJ45 output port on the local transmitter unit to the RJ45 input port
on the remote receiver unit using Cat5e/6/6a cable.
9. Connect the HDMI monitor to the HDMI output port on the remote receiver unit.
10. Connect the RS-232 serial DB9 male cable to the RS-232 port on the remote
receiver unit, then connect the RS-232 device.*
11. If you are using a remote control on the receiver side of the installation to control a
device on the transmitter side (such as a Blu-ray player), connect the IR-IN cable
(with red 3.5 mm connector) to the IR-IN port on the remote receiver unit.
Note: The IR-IN unit accepts a signal from a remote control and sends it to a device controlled
on the other end of the installation. Position the IR-IN unit in an unobstructed area that can
easily accept a remote control signal.
* See the HDBaseT Features Chart on page 3 of this manual for the features your product supports.
16-02-143-933493-EN.indd 7
7
2/16/2016 2:39:30 PM