Table of Contents
Advertisement
The MAIN address is for communication between the indoor unit and the outdoor
3
unit. Therefore, you must set it to operate the air conditioner properly.
It is required to set the RMC address if you install the wired remote controller
4
and/or the centralized controller.
If you install optional accessories such as the wired remote controller, centralized
5
controller, etc. see an appropriate installation manual.
If an optional accessory is not installed, you do not have to set the RMC
6
address. However, adjust K1 and K2 switches of the SW03 DIP switch to
"ON" position in this case.
7
Set the MAIN address by adjusting the rotary switch(SW01) from 0 to F. Each
indoor unit connected to the same outdoor unit must have different address.
i. e. If an indoor unit does not have an optional accessory
and its MAIN address is "0"
SW05
SW04
K9
K10 K11K12 K5 K6 K7 K8
8
Do not adjust K3 of the SW03 DIP switch，it is adjusted according to different
models by productor.
Switch No. Switch ON. Switch OFF
K3
FH052***
SW03
SW02
SW01
K1 K2 K3 K4
RMC
MAIN
FH070***
SW03
K1 K2 K3 K4
17
E-
Advertisement
Table of Contents
